iDirect iNFINITI 3000 Installation And Commissioning Manual page 37

5. When you have found the desired signal:
Tighten down the 4 bolts on the Yoke Cap that secure the Yoke Cap to
•
the Mast Pipe.
• Ensure that the Top Plate locking bolts are snug to allow azimuth
movement.
• Adjust the elevation until maximum dc voltage is obtained.
The rest of the azimuth adjustments will be made with the azimuth adjustment screws.
6. Fine tune azimuth until maximum dc voltage is obtained
7. Make sure azimuth and elevation are locked down
8. Adjust polarization until maximum dc voltage is obtained
9. Write down the final antenna pointing voltage reading and give the reading to the
operator at the Network Help Desk
10. In iSite, click Stop to exit the modem's antenna pointing mode
11. Power down the Satellite Router.
WARNING
iDirect iNFINITI series Installation and Commissioning Guide, Release 7.0
You must power down the Satellite Router before continuing to
the next section, "Fine-tune the Antenna Pointing and Cross
Polarization" on page
33
35.