Record The Geo Location - Mobile Secure Remotes Only; Set The Satellite Router's Geo Location; Verify The Satellite Router's Geo Location - iDirect iNFINITI 3000 Installation And Commissioning Manual

10

Record the Geo Location - Mobile Secure Remotes Only

NOTE
If for security reasons the Satellite Router's geographic location coordinates have not been
recorded by the Network Help Desk, you must enter these coordinates into the Satellite Router
manually, before the modem will acquire into the network.
WARNING

10.1 Set the Satellite Router's Geo Location

You will enter the latitude and longitude coordinates from the Satellite Router console via a special
command.
1. Open a HyperTerminal session on the Satellite Router's console. Alternatively,
you may telnet to the Satellite Router.
2. At the prompt, type the following command
latlong <your lat> [N|S] <your long> [E|W]
Format of the latlong Command
The format of the latlong command is:
When entering this command, replace the <lat> string with your current latitude in decimal
notation, followed by N for north or S for south. Replace the <long> string with your current
longitude in decimal notation, followed by E for east or W for west.

10.2 Verify the Satellite Router's Geo Location

You should verify that you have entered the correct geographic location coordinates.
1.
Type " extras show
for latitude and longitude.
2. Reset the Satellite Router.
iDirect iNFINITI series Installation and Commissioning Guide, Release 7.0
This section describes a specific operational scenario for
configuring remote Satellite Routers as both Mobile and Secure. If
your remotes do not fall into this category, skip this section.
It is critical that the geographic coordinates accurately reflect your
current geographic location. If the values are incorrect, your
Satellite Router will not be acquired into the network.
latlong <lat> [N/S] <long> [E/W]
" at the console prompt to display the current settings
41