Table of Contents
Advertisement
ADDITIONAL UPS FEATURES
Network Transient Protector
The network transient protector, shown in Figure 24, is located on the
rear panel and has jacks labeled IN and OUT. This feature
accommodates a single RJ-45 (10BaseT) network connector.
Low voltage models can also accommodate an RJ-11 telephone
connector that provides protection for modems, fax machines, or other
telecommunications equipment. As with most modem equipment, it is
not advisable to use this jack in digital PBX (Private Branch Exchange)
environments.
NOTE DO NOT connect any telephone or fax/modem equipment to the 230V models; only
network protection is available for 230V models.
1.
2.
46
t
Avaya
S9RM UPS Site Preparation, Installation and Operator's Manual
Connect the network or telephone (low voltage models only) cable
to the jack labeled IN.
Connect the input connector of the equipment you are protecting to
the jack labeled OUT.
NETWORK TRANSIENT PROTECTOR
Figure 24. Network Transient Protector
IN
OUT
S
05147387 Rev C
Advertisement
Table of Contents
