Testing New Batteries; Recycling The Used Battery Or Ups - Avaya S9RM Installation And Operator's Manual

Hide thumbs Also See for S9RM:

Table of Contents

UPS MAINTENANCE

Testing New Batteries

NOTE The batteries must be fully charged and the UPS must not be in Battery mode to

perform the self-test.

NOTE Load must be applied to the UPS to perform the battery test. Apply the following

load amounts according to the UPS rating: 50% load for 700 VA; 35% load for 1000 VA; 38%

load for 1500 VA; or 25% load for 2000 VA.

Press and hold the

After the test is complete, the

few seconds to turn off). If the

the battery connections. Call your Avaya service representative if the

problem persists.

Contact your local recycling or hazardous waste center for information

on proper disposal of the used battery or UPS.

Do not discard the UPS or the UPS batteries in the trash. This product contains sealed,

lead-acid batteries and must be disposed of properly. For more information, contact your

local recycling/reuse or hazardous waste center.

Do not discard waste electrical or electronic equipment (WEEE) in the trash. For proper

disposal, contact your local recycling/reuse or hazardous waste center.

Avaya

S9RM UPS Site Preparation, Installation and Operator's Manual

button for three seconds to initiate a self-test.

Do not dispose of the battery or batteries in a fire. Batteries may explode. Proper

disposal of batteries is required. Refer to your local codes for disposal requirements.

Do not open or mutilate the battery or batteries. Released electrolyte is harmful to the

skin and eyes. It may be toxic.

indicator should turn off (it may take a

indicator continues to flash, check

W A R N I N G

C A U T I O N

05147387 Rev C

Table of Contents