Turning The Ups Off; Initiating The Self-Test - Avaya S9RM Installation And Operator's Manual

OPERATION

Turning the UPS Off

NOTE Pressing the Off
down immediately.
To turn off the UPS:
1.
2.
3.

Initiating the Self-Test

NOTE The batteries must be fully charged and the UPS must not be in Battery mode to
perform the self-test.
NOTE Load must be applied to the UPS to perform the battery test. Apply the following
load amounts according to the UPS rating: 50% load for 700 VA; 35% load for 1000 VA; 38%
load for 1500 VA; or 25% load for 2000 VA.
Press and hold the
During the five-second test, the bar graph indicators cycle through twice.
If the alarm beeps or a UPS alarm indicator stays on, see Table 11 on
page 60.
32 t
Avaya S9RM UPS Site Preparation, Installation and Operator's Manual
button while the UPS is in Battery mode causes the UPS to shut
Prepare your equipment for shutdown.
Press and hold the Off
The UPS transfers to Standby mode (if utility power is available) and
removes power from your equipment.
Unplug the UPS; the UPS shuts down in five seconds. All front
panel indicators flash briefly twice prior to shutdown.
If you do not unplug the UPS, it remains in Standby mode.
button for three seconds to initiate the self-test.
button for approximately three seconds.
S
05147387 Rev C