Dtmf Signal Sender - NEC NEAX 2000 IPS Manual

DTMF Signal Sender

This programming is available only for the Adjunct Type (Analog Interface).
START
CM35 Specify the DTMF signal width.
CM35 Specify available timing to send DTMF sig-
nals after call origination from a PS by CM35
CM41
Y=45 or CM35 Y=46 or CM41 Y=0>27. Only
the shortest value data becomes effective
among the above.
END
DESCRIPTION
CHAPTER 3 SYSTEM DATA PROGRAMMING
• Y=26
(1) 00-63: Trunk Route No.
(2) 0 : 64 ms.
1 : 128 ms.
• CM35 Y=45
DP Sender Release Timing
(1) 00-63: Trunk Route No.
(2) 0 : 2 seconds
1 : 4 seconds
2 : 6 seconds
3 : 8 seconds
4 : 12 seconds
5 : 14 seconds
6 : 16 seconds
7 : 10 seconds
• CM35 Y=46
DTMF Sender Release Timing
(1) 00-63: Trunk Route No.
(2) 0 : 2 seconds
1 : 4 seconds
2 : 6 seconds
3 : 8 seconds
4 : 12 seconds
5 : 14 seconds
6 : 16 seconds
7 : 10 seconds
• CM41 Y=0
(1) 27: Interdigit Pause on Outgoing Call
(2) 03-14: 3-14 seconds
If no data is set, the default setting is 7 seconds.
– 142 –
WCS FEATURE PROGRAMMING
DATA
(1 second increment)
NWA-008855-001 Rev.1.0
avch3001.fm