NEC NEAX 2000 IPS Manual page 235

Soft Phone Wireless Handset
To answer a call on hold
1. Press the line key placed on hold.
2. Place the PS off-hook.
3. Start conversation with the call on hold.
<During canceling the interactive operation between PS and D
To originate a call from D
1. Dial a desired station number 2000, or select from the address book button, call logs, or member buttons.
2. The station answers to start conversation (3000 is displayed on the LCD of the station as a calling number).
To originate a call from PS
1. Dial a desired station number 2000.
2. The station answers to start conversation (3000 is displayed on the LCD of the station as a calling number).
To answer a call
1. A station dials D
term
2. The D SP30 rings.
3. Answer the call to start conversation with the handset of D
Service Conditions
General Conditions
1. This feature is available from Series 3400 software, and D
term
2. The D SP30 must be set as the main station, and a PS must be set as the sub station in system data pro-
gramming.
term
3. When the D
ton: off), regardless of the previous state.
4. The same service restriction class must be set for the D
5. If controlling of both of the main station and sub station when message waiting control is received from
voice mail is set in system data programming, message waiting is controlled on the main station and sub
station also during the interactive operation is cancelled.
6. The Multi-Line Operation - PS and the D
Conditions during Interactive operation
1. If the sub station (PS) sets Call Transfer or Do Not Disturb during interactive operation, the setting is set to
the main station (D
2. When a service is set using a feature access code from the D
of the access code are dialed.
3. After dialing only a trunk access code from the D
dial a destination number.
4. Answer operation is enabled only from the PS.
5. Exclusive Hold operation is disabled.
Page 38
Issue 6
term
SP30
term
SP30 station number 3000.
SP30 is started or restarted, the interactive operation is set (lamp of the handset switch but-
term
SP30), and is not set to the sub station (PS).
term
term
SP30.
term
term
SP30 and the PS.
term
SP30 interactive operation cannot be used together.
term
SP30, place the PS off-hook after all digits
term
SP30, it is impossible for the PS to go on-hook and
ND-91638-007(E)
SP30>
SP30 Version C or later is required.