Virtual Station Data Programming - NEC NEAX 2000 IPS Manual

VIRTUAL STATION DATA PROGRAMMING

NOTE:
Virtual trunk is not used from Series 3300 software. When using the office data in Series 3200
R6.2 software or before, execute the office data conversion. See
Conversion".
Office data settings for virtual trunk that are shown below are not required.
CM5A Y=00
CM30 Y=00, 02, 03, 04, 05, 40, 41, 42, 43
CM35 Y=00, 01, 04, 05, 09, 20, 76, 98
CM12 Y=16
CM85 Y=0-7
START
CM05 Assign the FP number to the FP for virtual sta-
tion of PS.
NOTE:
Assign the virtual PIM number that is con-
trolled by the FP for virtual station of PS.
NOTE:
CM14 Assign a Virtual station number to the required
LEN.
NOTE 1:
NOTE 2:
A
Page 88
DESCRIPTION
For the first data 56-63 of CM05
Y=1-7, follow the initial setting.
We recommend using Virtual PIM
No. 08-11.
Do not assign the same station num-
ber to the Virtual station number
and PS station number.
For Short Message Notification
(OAI), maximum 4 digits Virtual sta-
tion number must be assigned.
CHAPTER 3 SYSTEM DATA PROGRAMMING

VIRTUAL STATION DATA PROGRAMMING

• Y=0
(1) 56-63: FP No.
(2) 00: FP (for Virtual Station of PS)
INITIAL
• Y=8
(1) 56-63: FP No.
(2) 00 XX
INITIAL
XX: 08-11, 14-15: Virtual PIM No.
(1) XX ZZZ (LEN)
XX : 56-63: FP No.
ZZZ: 000-063: Port No.
(2) X-XXXXXXXX:Virtual Station No.
– 121 –
"Office Data
DATA
NOTE 1
NOTE 2
NWA-008855-001 Rev.1.0
avch3001.fm