Preset Dialing - NEC NEAX 2000 IPS Manual

General Description
This feature allows a PS user to confirm the number to be dialed before originating a call.
Configuration Application
Integrated Type and Adjunct Type
Operating Procedure
To originate a call:
1. Dial the desired number. The number will be stored and displayed on the LCD.
2. After confirming the number, press the L1 key.
3. To end a call, press the END key.
Service Conditions
1. A maximum of 40 digits (numbers 0 to 9, #, *, and pause) can be stored. A maximum of 11 digits can be
displayed on the LCD from left to right. When more than 12 digits are dialed, the digits exceeding 12 move
from right to left, displaying only the most recently dialed digits.
2. If a wrong number is dialed, press the FNC key. The number just dialed will be deleted. If the FNC key is
pressed for more than 0.5 seconds, the numbers will be deleted successively. Also, if no number is entered
for 20 seconds, the service is cleared, and the PS returns to the idle state (stand by status).
3. If the user dials a number after pressing the L1 key, it will be recognized as a DTMF signal sending.
4. PS Authorization is activated for every call origination.

Preset Dialing

ND-91638-007(E)
Preset Dialing
Page 27
Issue 6