System Installation Planning - Blaupunkt SA 2700 User Manual

1. System Installation Planning

Home and Away Arm Mode Planning
The alarm system supports two arming modes: Away Arm and Home Arm. Away Arm mode will
arm all accessory devices installed in the system to raise alarm when activated; Home Arm mode
will partial arm the system so that no intruder could get inside the premises without triggering an
alarm, yet the user can move within the house freely. Plan your device location in advance by
determine which area should remain unarmed in Home Arm mode, and decide which sensor
should be set to deactivated in Home Arm mode.
For more information, please see 7. Programming Mode – Device +/- and 8. Operation.
Device Operating Range
All devices in the alarm system have an approximate range of 100 feet (33 yards) in typical
domestic environment. The range may vary depending on different home condition. When
installing devices, make sure to test the device range before actually mounting the device.
Tamper Protection
Your Control Panel and accessory devices are protected from sabotage attempt by a "tamper
switch," which is triggered when the device cover is opened, or removed from mounted surface.
When the tamper switch is triggered, the alarm system will be activated to inform you. To make
sure the tamper switch functions properly, please make sure the switch is fully depressed against
the mounting surface when installing your Control Panel or devices.
System Extension
Aside from the devices included in the package, you can further improve the capability of your
alarm system by purchasing extra accessories. Including extra PIR Sensor or Door Contract to
extend your protection area; Remote Keypad for a secondary system operation platform; Smoke
Detector for fire protection; Temperature Sensor for High/Low Temperature report; and Power
Switch for energy
website http://www.blaupunkt.com/us/products/home-security/
devices.
For more information, please see 7. Programming Mode – Device +/-
General Device Location Guideline:

Avoid mounting the Control Panel and devices close to large metal objects or electrical
interference source, such as fridge and microwave oven as they could affect signal strength.

For devices that has tamper protection function, mount on even surface to ensure the tamper
is fully closed when mounted. For uneven surface, use extra packing material on the back.
management and Home Automation.
to learn more about accessory
1
Please check Blaupunkt