Table of Contents
Advertisement
Walk Test
Walk Test allows you to test the signal range of sensor and accessory devices. To test the device
1. Press the test or learn button on the device, refer to device user manual for detail.
2. If the Control Panel receives the signal, the screen will display device type, zone number,
attribute, name signal strength in 0~9 scale accordingly. (Signal strength 9 being the strongest)
GSM Signal
Use GSM Signal function to check the Control Panel GSM signal strength at current location. The
signal strength will be displayed in RSSI scale from 0~9. In order for the Control Panel to send and
receive report/command successfully, please make sure the RSSI value does not drop below 5 at
installed location. If the value drops below 5, the Control Panel may not be able to send report and
receive command successfully. You may consider relocating your Control Panel in this case.
Programming Mode
P-Mode allows the user to enter Programming Mode for detailed system setting, please refer to
next chapter for detail.
13
Hide quick links:
Advertisement
Table of Contents
