Advertisement
1. System Installation Planning
Away arm and Home Mode Planning
The alam system supports two arming modes: Away arm and Home. Away arm mode will arm all
accessory devices installed in the system to raise alarm when activated. Home Arm mode will partial
arm the system so that no intruder could get inside the premises withought triggering an alarm, yet
the user can move within the house freely. Plan your device location in advance by determining
which area should remain unarmed in Home Arm mode, and decide which sensor should still be
operating in Home Arm mode.
For more information, please see 5. Connect2Home Application.
Device Operating Range
All devices in the alarm system has an approximate range of 30 meters in typical domestic
environment. The range may vary depending on different home condition. When installing devices,
make sure the device range is tested before mounting the device.
Tamper Protection
Your accessory devices are protected from sabotage attempt by a "tamper switch," which is triggered
when the device is removed from mounted surface, or its cover opened. When the tamper switch is
triggered, the alarm system will be activated to inform you. To make sure the tamper switch functions
properly, please make sure the switch is fully depressed against the mounting surface when installing
your accessory devices.
System Extension
Aside from the devices included in the package, you can further improve the capability of your alarm
system by purchasing extra accessories. Including extra PIR Sensor or Door Contract to extend your
protection area; Remote Keypad for a secondary system operation platform; Smoke Detector for fire
protection; Temperature Sensor for High/Low Temperature report; and Power Switch for energy
management and Home Automation.
For more information, please see 5. Connect2Home Application.
General Device Location Guideline:
Avoid mounting the Control Panel and devices close to large metal objects or electrical
interference source, such as fridges and microwave ovens, as they could affect signal strength.
For devices that has tamper protection function, mount on even surface to ensure the tamper
is fully closed when mounted. For uneven surface, use extra packing material on the back.
1
Advertisement
