Blaupunkt SA 2700 User Manual page 12

3. Hook the Control Panel onto the plate, then slide the control panel left to secure the panel and
depress the tamper switch against the mounting plate. (Figures 4)
PIR Sensor
The PIR Sensor has knockouts on the back where plastic is thinner. The 2 central knockouts are
for flat wall mounting, and the four side knockouts are for corner mounting. (Figure 1)
1. Break through the knockouts, use the knockouts to mark position on wall or corner. (Figure 2)
Figure 1
Surface Fixing
Knockouts x 2
Corner Fixing
(Inside)
Knockouts x 4
2. Drill holes into the wall or corner using the knockouts as template, insert wall plug if required.
(Figure 3)
3. Screw the PIR Sensor base onto the wall or corner at marked location. (Figure 4) Then replace
the PIR Sensor cover onto the base.
Figure 3
Wall
Figures 4
Corner
9
Figures 2
Wall
Figure 4
Wall
Corner
Corner