Table of Contents
Advertisement
Remote Controller --- RC
Remote Keypad ---KP
Smoke Detector --- SD
Temperature Sensor --- TS
Outdoor Siren --- BX
Edit Devices
Use Edit Device to change setting for learned in devices. The screen will display available devices.
1. Select the device you want to edit, press "OK" to confirm.
2. Edit the device information according to the setting in Add Device.
Remove Devices
This function is used to remove an existing device from the system.
1. Select the device you want to remove, press "OK" to confirm.
2. You will be asked to confirm your action, press "OK" to confirm.
3. The device will be removed from the system.
Learn PSS (Optional Power Switch Required)
This function is used to learn in Power Switch (PSS) only.
1. Put the Power Switch into Learning Mode; refer to Power Switch manual for detail.
2. Select the Power Switch Channel # you desire, press "OK" to confirm.
3. Select the device you want to edit, press "OK" to confirm, the Control Panel will transmit signal
to Power Switch.
4. The Power Switch LED will flash 3 times upon receiving signal from Control Panel, the learning
is now complete
Learn RP (Optional Repeater Required)
This function is used to learn in Repeater only.
1. Put the Repeater into Learning Mode; refer to Power Switch manual for detail.
2. Select "Learn RP" and press "OK" to confirm. The Control Panel will transmit signal to Repeater.
3. The Repeater LED will light up if learning is successful.
SMS Keyword
The SMS Keyword is required if you want to remotely control the alarm system. When you send a
SMS command to the Control Panel, the correct SMS Keyword must be entered in the SMS
message for the Control Panel to recognize the command.
IMPORTANT NOTE: The SMS Keyword is capital letter sensitive. Please take care to note
down whether your SMS Keyword is entered in upper case or lower case
20
Hide quick links:
Advertisement
Table of Contents
