Blaupunkt SA 2700 User Manual page 22

Device +/-
Devices +/- allows you to add/remove /edit devices. The functions include:
Add Devices
Edit Devices
Remove Devices
Learn PSS
Add Devices
1. To learn in a device, select Add Device, press "OK" to confirm.
2. Press the test /learn button on the device, refer to device manual for detail.
3. If a signal is detected, the screen will display the device information, press "OK" to confirm.
If the device already exists in system, the screen will display "Already exist in system":
4. Select the Zone number for the device, press "OK" to confirm.
5. For Door Contact, PIR sensor, and EIR sensor, you need to select one of the three attributes for
the device, available attributes include:

Burglar (B)
When the device is triggered under Away Arm or Home Arm mode, a Burglar Alarm will be
activated immediately.
When the device is triggered during Entry or Exit countdown, the alarm will not be activated.

Home Omit (O)
When the device is triggered under Away Arm mode, a Burglar Alarm will be activated
immediately.
When the device is triggered under Home Arm mode, the alarm will not be activated.

Entry (E)
When the system is in any Arm mode, if an "Entry" device is triggered, the Control Panel will
start an Entry Delay countdown timer for the user to disarm the system.
After the delay period has expired and no correct PIN code has been entered, the Control
Panel will activate iren immediately to remind the user the delay period has expired.
If the Control Panel is not disarmed within 30 seconds after the delay period expires, a Burglar
Alarm will be reported. Disarming the Control Panel within the 30 second period will return the
system to Disarm mode and silence the siren. No alarm will be reported.
When the system is in Disarm mode, if a "Entry" is triggered, the Control Panel will make a
"ding-dong" Door Chime sound (if Door Chime function is not disabled).
6. Enter a name for the device, press "OK" to confirm. You can also leave the name blank.
7. The screen will display the final device information, press "OK" to confirm and complete learning
for the device
The device types are identified by the following abbreviation in the system:

Door Contact ---- DC

PIR Sensor ----- IR
19