Blaupunkt SA 2700 User Manual page 20

e) Door Chime
This function allows you to decide whether the Control Panel should emit a two-tone Door Chime
sound to notify the user when a Door Contact or PIR Detector set to Entry is triggered under
Disarmed mode.

Options available are : High, Low, Off

Door Chime Off is set as factory default.
f) Time
This is for you to program the current time to be displayed. (Hour & minute)

Use Up and Down keys to select the Hour and Minute, and press OK to confirm.
g) Date
This is for you to set the current date.

Use Up and Down keys to select the Month and Day, and press OK to confirm
h) Panel Siren
This is for you turn on/off the Control Panel's built-in siren. When turned off, the Control Panel will
not sound any warning when an alarm is activated.

Siren On is set as factory default.
Special Setting
Special setting provides more function for detail system configuration. The items available include
the following – see a) to h):
a) Alarm Length
This is for you to select the time length siren should sound when an alarm is activated.

Options available are: 1~15 minute in 1-minute increment.

3 minutes is set as factory default.
b) Exit Sound
This is for you to decide whether the Control Panel should sound count-down beeps and volume of
beep during Entry Time

Options available are: High, Low, Off

Exit Sound Lo (Exit sound Low) is set as factory default.
c) Entry Sound
This is for you to decide whether the Control Panel should sound count-down beeps and volume of
beep during the Entry Time.

Options available are: High, Low, Off

Entry Sound Lo (Entry sound Low) is set as factory default.
d) Interference
This is for you to turn on and off the interference detection feature. When interference detection is
turned On, if RF signal jamming is detected continuously for 30 seconds, the fault event will be
17