First Time Setup - Blaupunkt SA 2700 User Manual

This quick guide will take you through a step by step process of system initial setup.
NOTE: The First Time Setup process is only availble when you power on the Control Panel
for the first time. Once the process is completed, it will not appear again. All of the options
can be changed later again, do not worry if you make any mistakes.
Detail system setting can be done later by accessing the Programming Mode.
1. Remove the screw on the GSM Module compartment cover, lift the cover. (Figure 1)
2. Open the SIM Card base and insert SIM Card. Slide battery switch to ON position. (Figure 2)
3. Connect the AC power to your Control Panel.
The Green Power LED will light up, The Control Panel LCD will display :
3 s t e p s
s e t u p
You now begin the First Time Setup Process.
NOTE: The sensor and accessory devices included in the package has already been
included into the Control Panel. If you have purchased extra accessory devices, you can
add them into the Control Panel by pressing the learn/test button on devices during First
Time Setup Process. Refer to device manual for learn/test button location and detail.
1.
3 s t e p s
s e t u p
Press OK to continue.
2.
S e t D a t e / T i m e
Press OK to continue, follow the on screen instruction to set date and time. Use Up and Down key
to select the value and press OK to confirm.
3.
S e t 1 p h o n e
f o r a l e r t
Press OK to continue, enter a telephone number you want to report event to, then press OK to
confirm.
4.
S e t 1 P I N

3. First Time Setup

e a s y
( O K ? )
e a s y
( O K ? )
( O K ? )
n u m
( O K ? )
c o d e
( O K ? )
6