Blaupunkt SA 2700 User Manual page 31


PIR is slow to respond:
-- This is normal. PIR has sophisticated false arm filter setting to prevent accidental trigger. It
is also less sensitive when walking directly toward it:

PIR give false alarm:
-- Make sure pets have no access to protected area.
-- Make sure the PIR is not pointed at source of heat or moving objects
Door Contact

Door Contact LED flashes when activated:
-- Door Contact is on low battery or tamper switch triggered.

Door Contact does not respond to door/window opening
-- Batteries exhausted, please change battery.
-- The magnet is too far away from the Door Contact, please check the gap between the
magnet and the Door Contact. Reduce the gap and test the Door Contact again.
Remote Controller

Remote Controller LED glows dimly when any key is pressed
-- Remote Controller on low battery.
Factory Reset
The Factory Reset function will delete all learned in devices and returns all system setting to
default value. After the setting you will need to setup the system again from the beginning via First
Time Setup.
1. Power down Control Panel by disconnecting AC Power and switching off battery switch.
2. Apply AC Power while holding down the  key.
3. Release the  key when you hear a beep, the screen will display Enter Code.
4. Enter the following keys sequence: , OK
5. Press the key
6. Reset is complete and all programmed parameters are reset to factory default setting. All
devices are removed and must be learnt in again.
28