Mount Devices - Blaupunkt SA 2700 User Manual

This chapter will guide you through device mounting process.
After you complete First Time Setup process, if the Control Panel has already included accessory
devices, the screen should display:
M o u n t
s e e
Proceed to mount your sensors and accessory devices, tamper alarm will be disabled while the
Control Panel remains under this screen for you to install devices without triggering tamper alarm.
Find the location where the devices are to be mounted, test device signal strength at the mounting
location by putting the device at the location and pressing learn/test button on the device. Please
refer to device manual for learn/test button location and detail.
If the device is within range of the Control Panel, the screen will display the device information
accordingly. When you are certain the device can function properly at chosen location, proceed to
mount the device.
When mounting devices, make sure the device tamper is fully depressed, please refer to device
manual for tamper location.
Control Panel
The Control Panel tamper switch is located inside the mounting hole
1. Use the holes on the mounting plate, mark the position of the holes on the wall at chest height.
(Figures 1)
2. Drill two holes into the wall, insert wall plug if required, (Figures 2) screw the mounting plate
onto the wall at marked location. (Figures 3)
Figures 1

4. Mount Devices

D e v i c e s
m a n u a l
Figures 2
8
Tamper
Switch
Mounting
Holes
Figures 3