Blaupunkt SA 2700 User Manual page 26

Force Arm
When you arm the system, if any fault event exists, the Control Panel will sound a ding-dong
warning sound to indicate arming is prohibited, the fault event will be displayed on screen.
At this moment, you can first rectify all of the problems and then clear the Fault Display and you
will be able to arm the system normally.
If you want to Away/Home Arm the system without solving the fault event. Follow steps below to
Forced Arm.
1. Press ARM / HOME button on the Control Panel again, you will be ask to confirm Force Arm
action, press OK to double confirm.
For Remote Controller, Remote Keypad, press ARM / HOME button again.
2. The Exit Delay timer will begin to count down.
3. When the Exit Delay time is up, the Control Panel will enter the arm mode you selected.
Disarm
When the system is under Away Arm or Home Arm mode, to disarm the system:

For Control Panel, press the "Disarm" key and enter a User PIN Code, then press OK.

For Remote Keypad, enter a User PIN Code and press the "Disarm" key.

For Remote Controller, press "Disarm" key.
Alarm Activation

When a device set to Burglar is triggered, the alarm will be activated immediately.

When a device set to Entry is triggered, the Entry countdown timer will be activated. If the
system is not disarmed before the timer expires, an alarm will be activated.

When a device set to Home Omit is triggered in Home Arm mode, the device will be ignored. If
the device is triggered in Away Arm mode, the alarm will be activated immediately

When the tamper switch of the Control Panel or devices is triggered in Away Arm mode, the
alarm will be activated immediately.

You can trigger an Emergency alarm with the Remote Controller

You can trigger an Emergency/Fire/Medical alarm with the Remote Keypad. Please refer to
Remote Keypad manual

You can trigger an Emergency/Fire/Medical alarm with Control Panel keypad:
Press and hold both "1" and "3" key to trigger an Emergency Alarm.
Press and hold both "4" and "6" key to trigger a Fire Alarm.
Press and hold both "1" and "3" key to trigger a Medical Alarm.
Stopping the Alarm and Alarm Display
During an alarm, the Control Panel will sound the siren, and report to programmed telephone
number. The screen will display "ALARM! ALARM!" to notify the user
23