Tamper Protection - Blaupunkt SA 2700 User Manual

Stopping the Alarm

Enter a User PIN Code and press OK key on the Control Panel.

Enter a User PIN Code and press Disarm key on the Remote Keypad.

Press Disarm key on the Remote Controller

The alarm will be stopped; the device that triggered the alarm will be displayed on screen. Use
the Down button to scroll down the alarm event, the screen will display whether the system
reported successfully to programmed telephone number or not.

When you finish viewing the alarm event, the system will enter Disarm mode.
NOTE:
1. Remote Controller cannot be used to stop the Emergercy Alarm triggered by itself.
2. If you disarm the system with Remote Controller, the Control Panel screen will continue to
display "ALARM!ALARM!" message to remind you to check the alarm memory.
Alarm Memory
If an alarm was raised without being silenced during your absence, and the alarm reporting has
been carried out; the screen will continuously show "ALARM! ALARM!" to warn the user.

When you come back and disarm the system, the siren will sound for 3-second to warn you
that the intruder might still be inside your house.

View the alarm event by scrolling down with Down key, when you finish viewing the alarm
event, the system will enter Disarm mode.

Tamper Protection


When the system is under Away mode, if a tamper switch is triggered, an alarm will be
activated immediately. The Control Panel will send a SMS alarm event "Tamper" to
programmed SMS report telephone number, or dial the Voice report telephone number and
play "Burglar" message upon answer.

When the system is under Home or Disarm mode, if a tamper switch is triggered, the Control
Panel will not make any report or activate alarm. The fault LED will light up and a fault event
will be registered in the Control Panel.
Dialling and Call Acknowledgement
When an alarm is activated, the Control Panel will dial the programmed telephone numbers in
priority order for Voice Message or SMS Message report. When the Control Panel makes Voice
Message Reports:

After dialling, the Control Panel will delay 5 seconds then starts to play the message. It will
first play the general part of the recorded message (Address) then plays the specific alarm
message (Burglar, Fire, Medical or Emergency) depending on the nature of the alarm.

To ensure the call is successfully received by the recipient, the recipient should acknowledge
the message by pressing the appropriate button on his telephone set.

If the Control Panel does not receive any acknowledgement, the message will be repeated for
85 seconds. The Control Panel will then consider the call unsuccessful and dial the next
phone number in priority.
24