Cisco 7961G Administration Manual page 143

Chapter 7 Viewing Security Information, Model Information, Status, and Statistics on the Cisco IP Phone
Table 7-1 Status Messages on the Cisco IP Phone
Message
BootP server used
CFG file not found
CFG TFTP Size Error The configuration file is too
Checksum Error
Cisco IP Phone Administration Guide for Cisco CallManager, Cisco IP Phone 7961G/7961G-GE and 7941G/7941G-GE
OL-6966-01
Description
The phone obtained its IP
address from a BootP server
rather than a DHCP server.
The name-based and default
configuration file was not
found on the TFTP Server.
large for file system on the
phone.
Downloaded software file is
corrupted.
Possible Explanation and Action
None. This message is informational only.
The configuration file for a phone is created
when the phone is added to the
Cisco CallManager database. If the phone has
not been added to the Cisco CallManager
database, the TFTP server generates a
response.
File Not Found
Phone is not registered with
•
Cisco CallManager.
You must manually add the phone to
Cisco CallManager if you are not
allowing phones to auto-register. See the
"Adding Phones with Cisco CallManager
Administration" section on page 2-14
details.
If you are using DHCP, verify that the
•
DHCP server is pointing to the correct
TFTP server.
If you are using static IP addresses, check
•
configuration of the TFTP server. See the
"Network Configuration Menu" section
on page 4-6 for details on assigning a
TFTP server.
Power cycle the phone.
Obtain a new copy of the phone firmware and
place it in the TFTPPath directory. You
should only copy files into this directory when
the TFTP server software is shut down,
otherwise the files may be corrupted.
Status Menu
CFG
for
7-7