Minolta Di350 Service Manual page 138

FrameMaker Ver.5.5E(PC) Di350 DIS/REASSEMBLY, ADJUSTMENT
98.12.09
Symbol Part Name
PWB-A Master Board
PWB-A Cassette Main Board
PWB-A Duplex Main Board
PWB-H Double Feed Detecting
Board
PWB-I Paper Size Detecting
Board
PWB-L PPM Switching Board
PWB-N RAM Board
PWB-R Fuser Frame Register
Board
PWB-R Pre-Transfer Guide
Plate Register Board 1
PWB-R Pre-Transfer Guide
Plate Register Board 2
PU1 Power Supply Board 1
PU2 Power Supply Board 2
HV1 High Voltage Unit
INV Inverter Board
BCR BCR Board
HGB HGB Board
CCD CCD Board
Removal Procedure
Remove the Upper Cover. → Remove nine screws
and the MFB Box Cover. → Remove two screws and
the MFB Box Assy. → PWB-A
Remove the Connector Cover. → PWB-A
Remove the Duplex Unit. → Remove the Duplex Unit
Rear Cover. → PWB-A
Slide out the MP Cassette. → Remove one screw and
the PWB-H Mounting Bracket Assy. → PWB-H
Remove the Harness Cover. → Remove the Rear
Cover. → Remove two screws and the PW Board
Cover. → PWB-I
Remove the Harness Cover. → Remove the Rear
Cover. → Remove one screw and the PWB-L Mount-
ing Bracket Assy. → PWB-L
Remove the Upper Cover. → Remove nine screws
and the MFB Box Cover. → PWB-N
Remove the Fusing Unit. → Remove the rear lamp
cover. → PWB-R
Remove the Vertical Transport Unit. → Remove two
screws and two ground plates. → PWB-R
Open the Side Cover. → Remove the Imaging Car-
tridge. → Remove one screw and the PW Board
Cover. → PWB-R
Remove the Harness Cover. → Remove the Rear
Cover. → Remove the Left Cover. → Remove five
screws and the Reinforcement Bracket. → Remove
three screws and the PU1 Mounting Bracket Assy. →
PU1
Remove the Harness Cover. → Remove the Rear
Cover. → PU2
Open the Side Cover. → Remove the Imaging Car-
tridge. → Remove two screws and the HV1 Cover. →
HV1
Remove the Original Glass. → INV
Remove the Rear Left IR Cover. → Remove three
screws and the Harness Cover. → BCR
Remove the Original Glass. → Remove the Right IR
Cover. → Remove the Optical Cover. → Remove the
Rear Lower Cover. → Remove the Rear Upper Cover.
→ Remove the Shielding Plate. (U.S.A. and Canada
only) → Remove one screw and the Harness Cover.
→ Unplug nine connectors. → Remove five screws
and the HGB Mounting Bracket Assy. → HGB
See D-15.
D-8