Automatic Adjustment Of The Sensor - Konica Minolta bizhub C250 Service Manual

Hide thumbs Also See for bizhub C250:

Table of Contents

Field Service Ver. 1.0 Jul. 2005

Automatic adjustment of the sensor

• The detection level of the document through path sensor is automatically adjusted.

• The adjustment has two modes: [Initialize And Sensor Auto Adj.] and [ADF Sensor Auto

• Make this adjustment as appropriate after the replacement of the ADF board or in case

of the document detection error.

A. Adjustment procedure

1. Set the mode to the Service Mode.

2. Touch [ADF].

3. Touch [Sensor Auto Adjust].

4. Select [Initialize And Sensor Auto Adj.] or [ADF Sensor Auto Adj.].

5. Press the Start key.

6. If the result is OK touch the [END] key on the panel.

7. If the result is NG check the influencing sensor, replace it if necessary, and then make

readjustment.

8. Mechanical adjustment

4582F3E527DA

Table of Contents