Konica Minolta bizhub C250 Service Manual page 294

Field Service Ver. 1.0 Jul. 2005
Step
Setting the Device ID
1. Select [Service Mode] → [CS Remote Care], and touch [Detail Setting].
7
2. Touch [Machine Setting] → [Device ID], and input Device ID (nine digits).
☞
259
Setting the telephone number of the Center
1. Select [Service Mode] → [CS Remote Care], and touch [Detail Setting].
2. Touch [Machine Setting] → [Center Telephone Number].
8
3. Input the telephone number of the Center using the 10-Keys Pad and [P], [T], [W], [-] keys.
☞
259
Inputting the Device telephone number
1. Select [Service Mode] → [CS Remote Care], and touch [Detail Setting].
2. Touch [Machine Setting] → [Device Telephone Number].
9
3. Input the Device telephone number using the 10-Key Pad and [P], [T], [W], [-] keys.
☞
259
Inputting the AT command for initializing the modem
1. Select [Service Mode] → [CS Remote Care] → and touch [Detail Setting].
2. Touch [AT Command].
3. Input AT Command.
10
NOTE
• Change this Command only when it is necessary. (They do not need to be changed in
normal condition.)
• For details on AT Command, see the manual for the modem.
☞
260
Setting the DIPSW for CS Remote Care
NOTE
11
• This setting is not normally necessary. Take this step only when necessary in a specific
connecting condition.
Executing the initial transmission
1. Select [Service Mode] → [CS Remote Care], and touch [Detail Setting].
2. Touch [initial transmission] on the right bottom of the screen to start initial transmission.
3. When the machine is properly connected with the Center, CS Remote Care setting screen will
be displayed.
12
NOTE
• The initial transmission key at the right bottom of the screen will be displayed only
when the Center ID, the Device ID, Telephone number of the Center and the Device tele-
phone number have been input.
☞
258
Procedure
10. Service Mode
251