Table of Contents
Advertisement
Table-Mounting the Chassis
Danger:
• Only trained and qualified personnel should install or replace this equipment.
Caution:
• There are no handles or hand grips on the 7450 ESS-1. Lift the router from underneath. Do
• The router should be installed on an elevated flat surface, off the floor.
• 7450 ESS-1 routers must not be stacked taller than 8 units high.
• The ventilation and maintenance clearance dimensions are the same for table-mounted units
The 7450 ESS-1 chassis can be installed on a flat surface, such as a tabletop or shelf. Rubber
footpads are included in with each accessory kit. It is optional to remove the factory installed rack
mounting brackets.
Before you begin, verify:
•
•
Figure 7
7450 ESS-1
not lift the router by the MDA slots.
as for rack-mounted units. See
The surface is sturdy and can support the weight of the router, or a stack of routers (up to
8 units high) and attached cables.
Ventilation and maintenance requirements are met.
displays the locations to attach the footpads on the bottom side of the chassis.
Chassis Clearance Requirements on page
Installing the 7450 ESS-1
30.
Page 43
Advertisement
Table of Contents
