Table of Contents
Advertisement
Installing MDAs
To install an MDA:
Step 1
Step 2
Step 3
Step 4
Step 5
Step 6
Each MDA has a Power and Status LED. For a description of the LEDs for each MDA model,
refer to
Page 78
Remove the MDA from the packaging and place on a flat anti-static work surface. Avoid
touching board components and connector pins.
If an MDA slot cover is installed in the slot, loosen the cover's captive screws and remove
cover.
Insert the MDA into MDA slot 1 (left) or 2 (right). Align the MDA with the slot guides
and the captive screw with the threaded receptacle (see Key 2 in
Tighten the captive screws to secure the MDA. Do not over-tighten. The maximum
recommended torque is 10 lbf.in.
Check the Power LED.
Attach cables to the MDA ports.
Appendix A: LEDs and Optics on page
81.
Figure
19).
7450 ESS-1
Advertisement
Table of Contents
