Maintain 802.11B Client Connections Using Link Integrity - HP WL520 User Manual

4. Enter the
Default Gateway IP Address Default Gateway IP Address
Default Gateway IP Address Default Gateway IP Address
check box.
5. Reboot the HP WL520 unit for the changes to take affect.

maintain 802.11b client connections using link integrity

maintain 802.11b client connections using link integrity
maintain 802.11b client connections using link integrity maintain 802.11b client connections using link integrity
NOTE:
This feature is only applicable to 2.4 GHz (802.11b) cards.
The Link Integrity feature checks the link between the HP WL520 and the nodes on the backbone. These nodes are listed by
their IP address on the Link Integrity IP Address Table, and serve as backup. If the link goes down, the client will connect to
another HP WL520 in your network that still communicates with the server.
Figure 2-10 Figure 2-10 Li i nk Integri i t t y L nk Integr y
Figure 2-10 Figure 2-10 Link Integrity Link Integrity
configure link integrity configure link integrity
configure link integrity configure link integrity
1. From the HTTP interface, click on the
2. Click the button in the
Edit Edit Edit Edit
3. Enter the IP Address of the host computer you want to check and add comments to identify the computer if you wish. This
Target IP Address is enabled as soon as it is entered in the table. Click
4. Set the following parameters as needed:
– - the interval between link integrity checks. Range is 500 - 15000 ms in increments of 500 ms; default is
Poll Interval Poll Interval Poll Interval Poll Interval
500 ms.
–
Poll Retransmissions Poll Retransmissions Poll Retransmissions Poll Retransmissions
5. Click to select the
Enable Link Integrity Enable Link Integrity Enable Link Integrity Enable Link Integrity
disable link integrity disable link integrity disable link integrity disable link integrity
To disable Link Integrity check for all clients, deselect the
To disable Link Integrity check to a certain host computer, click on the
to Disable.
Status Status Status Status
, the and
Primary Primary Secondary DNS IP Addresses Secondary DNS IP Addresses
Primary Primary Secondary DNS IP Addresses Secondary DNS IP Addresses
button and select the
Configure Configure Configure Configure
.
Target IP Address Table Target IP Address Table Target IP Address Table Target IP Address Table
- the number of times a poll should be retransmitted before the link is considered down.
check box.
Other Network Settings
, and select the
Network > Link Integrity Network > Link Integrity Network > Link Integrity Network > Link Integrity
.
OK OK OK OK
check box.
Enable Link Integrity Enable Link Integrity
Enable Link Integrity Enable Link Integrity
Edit Edit button in the Tar r get IP Address Table T T T a g
Edit Edit
Enable DHCP Server Enable DHCP Server
Enable DHCP Server Enable DHCP Server
tabs.
et I P Address Table and set the
arget IP Address Table arget IP Address Table
2-10