configure the hp
configure the
hp WL520
WL520 device as a dhcp server
configure the
configure the
hp
hp
WL520
WL520
NOTE:
You must have at least one entry in the DHCP Server client IP Address assignment table before you can enable the
DHCP Server Status feature.
[Device Name]>set dhcpstatus disable
[Device Name]>set dhcpippooltable 0 startipaddr <start ip address>
endipaddr <end ip address>
[Device Name]>set dhcppridnsipaddr <primary dns ip address>
[Device Name]>set dhcpsecdnsipaddr <secondary dns ip address>
[Device Name]>set dhcpstatus enable
[Device Name]>reboot 0
maintain 802.11b client connections using link integrity
maintain 802.11b client connections using link integrity
maintain 802.11b client connections using link integrity
maintain 802.11b client connections using link integrity
NOTE:
This feature is only applicable for 2.4 GHz (802.11b) cards.
[Device Name]>show linkinttbl (this shows the current links)
[Device Name]>set linkinttbl <1-4 (depending on what row in the table you wish
to address)> ipaddr <ip address of the host computer you want to check>
[Device Name]>set linkintpollint <the interval between link integrity checks>
[Device Name]>set linkintpollretx <number of times to retransmit before
considering the link down>
[Device Name]>set linkintstatus <enable>
[Device Name]>reboot 0
change your wireless interface settings
change your wireless interface settings
change your wireless interface settings
change your wireless interface settings
enable/disable interference robustness
enable/disable interference robustness
enable/disable interference robustness
enable/disable interference robustness
–
3 = wireless card in Slot A
–
4 = wireless card in Slot B
[Device Name]>set wif <3 or 4> interrobust <enable/disable>
enable/disable closed system
enable/disable closed system
enable/disable closed system
enable/disable closed system
–
3 = wireless card in Slot A
–
4 = wireless card in Slot B
[Device Name]>set wif <3 or 4> closedsys <enable/disable>
NOTE:
When disabled, a client configured with the Network Name "ANY" can connect to the HP WL520. This feature is
only available for 802.11b wireless cards.
enable/disable load balancing
enable/disable load balancing
enable/disable load balancing
enable/disable load balancing
–
3 = wireless card in Slot A
–
4 = wireless card in Slot B
[Device Name]>set wif <3 or 4> ldbalance <enable/disable>
device as a dhcp server
device as a dhcp server
device as a dhcp server
Other network settings
6-15