HP WL520 User Manual page 68

initializing the ip address using normal cli initializing the ip address using normal cli initializing the ip address using normal cli initializing the ip address using normal cli
After installing the serial port cable, you may use the CLI to communicate with the HP WL520. You may use most generic
terminal programs, such as HyperTerminal. Once the IP Address has been assigned, use the HTTP Interface or the CLI to
complete configuration. Many web sites offer shareware or commercial terminal programs you can download.
Use the following procedure to initialize the HP WL520 IP Address.
1. Open your terminal emulator, and then set the following connection properties:
Com Port: <COM1, COM2, etc., depending on your computer>
Baud rate: 9600
Data Bits: 8
Stop bits: 1
Flow Control: None
Parity: None
2. Enable the "ASCII Setup" settings by selecting "Send line ends with line feeds". Result: HyperTerminal sends a line return at
the end of each line of code.
3. Press the button on the HP WL520 (located on the LED Indicator side of the unit). Result: The terminal display shows
RESET RESET RESET RESET
Power On Self Tests (POST) activity, and then displays a CLI prompt, similar to the example below. This process may take
up to 90 seconds.
Please enter password: Please enter password:
Please enter password: Please enter password:
[Device name]>
4. Enter the password (default is "public"). Result: The terminal displays a welcome message and then the CLI Prompt:
> > > >
[Device name]
5. Enter . Result: Network parameters appear:
show ip
[Device name]> show ip
IP Address: 10.0.0.1
IP Mask: 255.0.0.0
Default Router: 10.0.0.1
Default TTL: 64
Address Type: 1
6. Change the IP Address and other network values using
(use your own IP Address and IP Mask). Result: After each entry the CLI reminds you to reboot; however wait to reboot
until all commands have been entered.
[Device name]> set ipaddrtype static
[Device name]> set ipaddr <IP Address>
[Device name]> set ipsubmask <IP Mask>
[Device name]> set ipgw <Default Gateway IP Address>
[Device name]> reboot 0
7. After the HP WL520 reboots, verify the new IP Address by reconnecting, and then entering a
Step 5). Alternatively, you can use the
8. When the proper IP Address is set, use CLI or the HTTP Interface over the LAN to complete configuration and manage
operations.
and
set set set set reboot reboot reboot reboot
network command from networked computers to test the new IP Address.
ping ping ping ping
CLI commands, similar to the example dialog below
show ip show ip
show ip show ip
CLI statement (as in
5-7