If You Encounter Problems - HP WL520 User Manual

802.1x security and wireless distribution systems 802.1x security and wireless distribution systems 802.1x security and wireless distribution systems 802.1x security and wireless distribution systems
Wireless distribution systems are setup using specific ports on the HP WL520 unit and frequency channels in the wireless
interface cards. To use 802.1x with WDS, you need to set the 802.1x Security Mode to Mixed (WEP and 802.1x), to make
sure that the HP WL520 and the clients share the same encryption key (Key 1).
IT managers can install HP WL520 access points with Wi-Fi radios and gradually migrate to the 802.11a radios without
replacing their access points or client devices. As 802.11a radios become available, they can simply pop out one of the Wi-Fi
radios from one of the dual slots and replace it with an 802.11a radio.

if you encounter problems...

if you encounter problems...
if you encounter problems... if you encounter problems...
Cannot Associate with a Network. When the Client Manager starts, it automatically looks for a network. If it cannot
associate with a network, you will see a message reminding you to update the case-sensitive Network Name in the current
Client Manager Configuration Profile.
NOTE:
Ask your network administrator for the correct Network Name, and then edit the profile by opening Client Manager.
Select
Actions -> Add/Edit Configuration Profile -> Edit Profile -> Basic Actions -> Add/Edit Configuration Profile -> Edit Profile -> Basic
Actions -> Add/Edit Configuration Profile -> Edit Profile -> Basic Actions -> Add/Edit Configuration Profile -> Edit Profile -> Basic
For more information, please refer to your PC Card documentation.
If the Network Name is the same in both the client and the HP WL520 device, then verify the settings in the Security
Properties table, which includes encryption settings.
Other Errors. Systematically double-check the HP WL520 unit settings, especially the IP Addresses and the client IP
Address Pool.
For more information, please refer to Troubleshooting in this guide.
If you encounter problems...
. Enter the Network Name and then click OK. K O O K
OK
2-21