Cli Command Types; Operational Cli Commands - HP WL520 User Manual

The following lists display the results of using the help and show commands in the Bootloader CLI:
[DeviceName]>help
Command List
=============
set
show
reboot
help
Command Usage
=============
set <parameter name> <parameter value> <CR>
show <CR>
reboot <number f seconds> <CR>
help <CR>
Parameter List
==============
sysname
ipaddrtype
ipaddr
ipsubmask
ipgw
tftpipaddr
tftpfilename
[DeviceName]>show
sysname
ipaddrtype
ipaddr
ipsubmask
ipgw
tftpipaddr
tftpfilename

cli command types

cli command types cli command types cli command types
This guide divides CLI Commands into two categories: Operational and Parameter Control.

operational cli commands

operational cli commands
operational cli commands operational cli commands
This type affects Access Point behavior, such as downloading, rebooting, and so on. After entering commands (and
parameters if any) press the Enter key to execute the Command Line.
Operational commands include.
? - (Question Mark) Lists CLI Commands or parameters, depending on usage.
done, exit, quit - Terminates the CLI session
download - Uses TFTP server to download "image", "config", or "bootloader upgrade" files to Access Point.
help - Displays general CLI help information or command help information, such as command usage and syntax
history - Remembers commands to help avoid re-entering complex statements
passwd - Sets the Access Point CLI password
reboot - Reboots the Access Point in specified time
search - Lists the parameters in a specified Table
upload - Uses TFTP server to upload "config" files from Access Point to TFTP default directory or specified path.
Description
===========
Set system parameters
Show running system information
Reboots the system
Description of commands, command usage, and parameters
Description
===========
System Name
System IP Address Assignment Type
System IP Address
System IP Mask
System Default Gateway IP Address
TFTP Server IP Address
Image or Binary File Name
<value of sysname>
<value of ipaddrtype>
<value of ipaddr>
<value of ipsubmask>
<value of ipgw>
<value of tftpipaddr>
<value of tftpfilename>
CLI command types
6-4