Auto Channel Select (Acs) - HP WL520 User Manual

–
Enable Interference Robustness Enable Interference Robustness
Enable Interference Robustness Enable Interference Robustness
the wireless signal. This feature is only available for 802.11b wireless cards.
– . Check this box to allow only clients configured with your specific Network Names to access the
Enable Closed System Enable Closed System
Enable Closed System Enable Closed System
HP WL520. When disabled, a client configured with the Network Name "ANY" can connect to the HP WL520. This
feature is only available for 802.11b wireless cards.
– . Enable this option so clients can evaluate which access point to associate with, based on current AP
Enable Load Balancing Enable Load Balancing Enable Load Balancing Enable Load Balancing
loads, to more evenly balance the load between APs. This feature is only available for systems using two 802.11b wireless
cards.
–
Enable Medium Density Distribution Enable Medium Density Distribution
Enable Medium Density Distribution Enable Medium Density Distribution
nearby APs. This feature is only available for 802.11b wireless cards.

auto channel select (acs)

auto channel select (acs) auto channel select (acs) auto channel select (acs)
Auto Channel Select (ACS) tests available channels and selects one according to its signal strength. The channel range is set
by the regulatory agency responsible for your geographic region. Using a probe, the HP WL520 device scans appropriate
channels and selects the radio frequency channel with the best signal to noise ratio (i.e., signal strength). ACS is enabled by
default; however, if you plan to use WDS setup then you must disable ACS.
disabling acs disabling acs disabling acs disabling acs
1. From the Web interface, select
2. Deselect the check box to disable Auto Channel Select.
3. Select a frequency channel from the drop-down menu. The clients automatically sense the channel and will configure
themselves to reassociate on the new channel.
WARNING:
!
On changing the status you mu t eboot your unit, which w l disconne t a l cli n s f om the HP WL520.
enabling acs enabling acs enabling acs enabling acs
1. From the Web interface, select
2. Select the check box to
WARNING:
!
On changing the status you mu t eboot y u unit
. Enable this option if other electrical devices in the 2.4 GHz range may be interfering with
. Enable this option to automatically notify client stations of roaming thresholds for the
then click on the
Configuration Configuration Configuration Configuration
s r
Configuration Configuration then click on the
Configuration Configuration
Enable Auto Channel Select Enable Auto Channel Select .
Enable Auto Channel Select Enable Auto Channel Select
s r o r , w i h w l disconnect all c i n s f om the HP WL520. h c
Change your Wireless Interface Settings
tab.
Interfaces Interfaces Interfaces Interfaces
il c l e t r
Interfaces Interfaces tab.
Interfaces Interfaces
il l e t r
2-13