Maintain 802.11B Client Connections Using Link Integrity; Configure Link Integrity - HP WL520 User Manual

4. Enter the following information:
— Start IP Address Start IP Address Start IP Address Start IP Address
—
End IP Address End IP Address End IP Address End IP Address
—
Default Lease Time (optional) Default Lease Time (optional) Default Lease Time (optional) Default Lease Time (optional)
automatically renews IP Addresses without client notification. Default is 86400 seconds.
— Maximum Lease Time (optional) Maximum Lease Time (optional)
Maximum Lease Time (optional) Maximum Lease Time (optional)
automatically renews IP Addresses without client notification. Default is 86400 seconds.
— — — — Comment (optional) Comment (optional)
Comment (optional) Comment (optional)
— - IP Pools are enabled upon entry in the table. Use the
Status Status Status Status
5. Enter the
Default Gateway IP Address Default Gateway IP Address
Default Gateway IP Address Default Gateway IP Address
check box.
6. Reboot the WL520 unit for the changes to take affect.

maintain 802.11b client connections using link integrity

maintain 802.11b client connections using link integrity
maintain 802.11b client connections using link integrity maintain 802.11b client connections using link integrity
NOTE:
This feature is only applicable to 2.4 GHz (802.11b) cards.
The Link Integrity feature checks the link between the WL520 and the nodes on the backbone. These nodes are listed by their
IP address on the Link Integrity IP Address Table, and serve as backup. If the link goes down, the client will connect to another
WL520 in your network that still communicates with the server.

configure link integrity

configure link integrity
configure link integrity configure link integrity
Figure 2-13 Figure 2-13 Link Integrity Link Integrity
Figure 2-13 Figure 2-13 Link Integrity Link Integrity
1. In the Web Interface, click the
2. Select the Link Integrity Link Integrity
Link Integrity Link Integrity
3. Click the Edit Edit button in the
Edit Edit
4. Enter the IP Address of the host computer you want to check and add comments to identify the computer if you wish. This
Target IP Address is enabled as soon as it is entered in the table. Click
5. Set the following parameters as needed:
– - the interval between link integrity checks. Range is 500 - 15000 ms in increments of 500 ms; default is
Poll Interval Poll Interval
Poll Interval Poll Interval
500 ms.
–
Poll Retransmissions Poll Retransmissions Poll Retransmissions Poll Retransmissions
6. Click to select the
Enable Link Integrity Enable Link Integrity Enable Link Integrity Enable Link Integrity
- the default time value for clients to retain the assigned IP Address. DHCP
- the maximum time value for clients to retain the assigned IP Address. DHCP
, the and
Primary Primary
Primary Primary
Configure Configure button and select the
Configure Configure
sub-tab.
Target IP Address Table Target IP Address Table .
Target IP Address Table Target IP Address Table
- the number of times a poll should be retransmitted before the link is considered down.
check box.
button to disable or delete existing table entries.
Edit Edit Edit Edit
, and select the
Secondary DNS IP Addresses Secondary DNS IP Addresses
Secondary DNS IP Addresses Secondary DNS IP Addresses
Network Network tab.
Network Network
.
OK OK OK OK
Other Network Settings
Enable DHCP Server Enable DHCP Server
Enable DHCP Server Enable DHCP Server
2-12