Table of Contents
Advertisement
parameter tables
parameter tables
parameter tables
parameter tables
Objects contain groups that contain both parameters and parameter tables.
Use the following Tables to configure the Access Point. The Access Point CLI is under development as this document is being
prepared; therefore, some table cells are blank where a feature has not yet been implemented or information needs validation.
Columns used on the tables include:
— Name - Parameter, Group, or Table Name
— Type - Data type
— Values - Value range, and default value, if any
— ACC. - Indicates access type. R = Read Only (show), RW = Read-Write, can be "set", W = Write Only
— CLI Parameter - Parameter name as used in the Access Point
Access Point network objects are associated with Groups. The network objects are listed below and associated parameters are
described in the following Parameter Tables:
System parameters
- Access Point system information
Inventory management information
Network parameters
- IP and Ethernet information
Wireless interface parameters
Autochannel Select (ACS)
SNMP IP access table parameters
SNMP host table parameters
Primary and backup RADIUS server table parameters
Telnet parameters
- Telnet Port setup
Serial port parameters
TFTP server parameters
HTTP (web browser) parameters
Link Integrity group
- Monitor link status
Link Integrity IP target table
Wireless interface security table
Ethernet filtering table
- Enable and disable specific addresses
IAPP parameters
- Enable or disable the Inter-Access Point Protocol
Static MAC address filter table
Spanning tree parameters
Storm threshold parameters
MAC access control table parameters
DHCP server parameters
DHCP server table for IP pools
SpectraLink VoIP parameters
- Hardware, firmware and software version information
- Wireless Interface (or you can say Wireless Card) Information
- Management information
-
-
- Serial Port setup
- Set up for file transfers. Specify IP Address, file name, and file type.
- Use the graphical web browser interface
-
- Security settings
- Enable and disable specific addresses
- Used to help prevent network loops
- Set multicast rate
- Control access my Media Access Control number
- Enable or disable dynamic host configuration
-
- Enable or disable SpectraLink Voice over IP feature
- RADIUS Authentication and Accounting information
Parameter tables
6-19
Advertisement
Table of Contents
