Table of Contents
Advertisement
set wep encryption for each wireless interface
set wep encryption for each wireless interface
set wep encryption for each wireless interface
set wep encryption for each wireless interface
Figure 2- - 6
Figure 2 6
Figure 2-6
Figure 2-6
WEP Encryption
WEP Encryption
W
WEP Encryption
EP Enc
rypti
1.
Click on the
Security > Encryption
Security > Encryption
Security > Encryption
Security > Encryption
2.
Click inside the check box to
3.
Type in an
encryption key
encryption key
encryption key
encryption key
NOTE:
The HP WL520 device supports both 40- and 128-bit cards. 40-bit cards support key lengths of 5 alphanumeric
characters. 128-bit cards support key lengths of 13 alphanumeric characters.
4. Select which key to use for WEP encryption. Client stations must have the same encryption key to be able to
communicate with the HP WL520 device.
change passwords
change passwords
change passwords
change passwords
1. Click on the
Management
Management
Management
Management
default passwords for each interface is public.
NOTE:
We strongly urge your to change the default passwords to restrict access to your network devices to authorized
personnel. We also recommend that you document your HP WL520 configuration using the work sheets provided for
you in
Recording Your Configuration
the
Reset to Factory Default
on
tabs.
enable WEP encryption
enable WEP encryption
enable WEP encryption
enable WEP encryption
based on the type of card present in each slot.
tab and change the default passwords for the SNMP, Telnet/CLI, and HTTP interfaces. The
Settings. If you lose or forget your password settings, you can always perform
procedure.
Set Basic Configuration Parameters
on a wireless card.
2-6
Advertisement
Table of Contents
