Set Http Interface Management Services; Configure Serial Port Interface Settings; Other Security Configuration Settings; Configure Your Mac (Address) Access Control Table - HP WL520 User Manual

set http interface management services

set http interface management services
set http interface management services set http interface management services
From the drop-down menu, select which physical interface(s) can be used to manage the HP WL520 device using the HTTP
management interface.
Choose between:
— Disabled (all interfaces)
— Ethernet only enabled
— Wireless A only enabled
— Wireless B only enabled
— All Interfaces enabled
Enter the HTTP communication port number. Default is 80.

configure serial port interface settings

configure serial port interface settings configure serial port interface settings configure serial port interface settings
The serial port interface on the HP WL520 device is enabled at all times. You can set the following parameters as needed:
– . Select the serial port speed (bits per second). Choose between 2400, 4800, 9600, 19200, 38400, or 57600;
Baud Rate Baud Rate Baud Rate Baud Rate
the default Baud Rate is
– . Select either
Flow Control Flow Control Flow Control Flow Control
NOTE:
To avoid unexpected performance of your HP WL520, leave the setting Flow Control to its default value (none) unless
you are sure what this setting should be.

other security configuration settings

other security configuration settings other security configuration settings other security configuration settings
Control access to the HP WL520 device using MAC Address authentication, WEP encryption, or 802.1x security settings

configure your mac (address) access control table

configure your mac (address) access control table configure your mac (address) access control table configure your mac (address) access control table
The MAC Authentication tab allows you to build a list of stations, identified by their MAC addresses, authorized to access the
HP WL520 device within your network. The list is stored inside each HP WL520 within your network.
Figure 2-17 Figure 2-17 Figure 2-17 Figure 2-17 Security Configuration Screen - MAC Authentication Security Configuration Screen - MAC Authentication Security Configuration Screen - MAC Authentication Secu rity Co gurat nfi
–
Enable MAC Access Control Enable MAC Access Control
Enable MAC Access Control Enable MAC Access Control
– Operation Type Operation Type . Choose between
Operation Type Operation Type
Control Table are filtered.
9600 9600 .
9600 9600
(default) or (software controlled) data flow control.
None None None None Xon/Xoff Xon/Xoff Xon/Xoff Xon/Xoff
ion Sc reen - MAC Au hentica t
. Check this box to enable the Control Table.
Passthru Passthru and Block Block . This determines how the stations identified in the MAC Access
Passthru Passthru Block Block
Other Security Configuration Settings
tion
2-17