Mac Access Control; Radius Authentication Settings - HP WL520 User Manual

mac access control

mac access control
mac access control mac access control
setup mac (address) access control table setup mac (address) access control table
setup mac (address) access control table setup mac (address) access control table
[Device Name]>set macaclstatus <enable> macacloptype <passthru, block>
[Device Name]>reboot 0
add an entry to the mac access control table add an entry to the mac access control table
add an entry to the mac access control table add an entry to the mac access control table
[Device Name]>set macacltbl <index> macaddr <MAC Address, such as 00:12:34:56:78:ab>
status <enable>
[Device Name]>show macacltbl
disable or delete an entry in the mac access control table disable or delete an entry in the mac access control table
disable or delete an entry in the mac access control table disable or delete an entry in the mac access control table
[Device Name]>set macacltbl
[Device Name]>show macacltbl
NOTE:
For larger networks that include multiple HP WL520 devices, you may prefer to maintain this list on a centralized
location using the

radius authentication settings

radius authentication settings
radius authentication settings radius authentication settings
set radius parameters set radius parameters set radius parameters set radius parameters
[Device Name]>set radmacaccctrl <enable>
[Device Name]>set radiustbl <index> ipaddr <RADIUS IP address>
[Device Name]>set radauthlifetm <900-43200 milliseconds (in 60 sec increments)>
[Device Name]>show radiustbl
configure radius server configure radius server
configure radius server configure radius server
[Device Name]>set radiustbl <index> status <enable> ipaddr <RADIUS IP address>
port <user defined> ssecret <user defined> responsetm <1 to 4 seconds>
maxretx <1 to 10 times> type <authentication, accounting>
[Device Name]>show radiustbl
[Device Name]>reboot 0
<index> status <disable/delete>
RADIUS authentication settings.
Other network settings
6-18