Other Network Settings; Configure The Hp Wl520 Device As A Dhcp Server - HP WL520 User Manual

other network settings

other network settings other network settings other network settings
You may want to set other configuration parameters for your HP WL520 unit, such as:
–

Configure the HP WL520 device as a DHCP server

– Maintain 802.11b client connections using Link Integrity checking
– Change your Wireless Interface settings
– Configure which physical interface will be used to manage the HP WL520 unit
– Control access to the HP WL520 device using MAC Address authentication, WEP encryption or 802.1x security settings
Refer to Configuring Advanced Features
configure the hp configure the configure the hp hp WL520 device as a dhcp server hp WL520 WL520 device as a dhcp server
configure the WL520
Use DHCP configuration to provide dynamic client IP Addresses from one or more IP Pool Tables. Enable the DHCP Server to
allow the HP WL520 to assign clients IP Addresses from IP Pool Tables. Deselect the Status check box to prevent client IP
Address assignment from the HP WL520.
NOTE:
You must have at least one entry in the DHCP Server client IP Address assignment table before you can enable the
DHCP Server Status feature.
Figure 2-9 Figure 2-9 Network Configuration Screens - DHCP Server Network Configuration Screens - DHCP Server
Figure 2-9 Figure 2-9 Network Configuration Screens - DHCP Server Network Configuration Screens - DHCP Server
1. From the HTTP interface, click on the
2. Click on the button in the IP Pool Table.
Add Add
Add Add
3. Enter the following information:
— — — — Start IP Address Start IP Address S Start IP Address tar P Address t I
— — — — End IP Addres s s End IP Address End I Add End IP Address P re s
—
Default Lease Time Default Lease Time
Default Lease Time Default Lease Time
automatically renews IP Addresses without client notification. Default is 86400 seconds.
—
Maximum Lease Time Maximum Lease Time
Maximum Lease Time Maximum Lease Time
automatically renews IP Addresses without client notification. Default is 86400 seconds.
— (optional)
Comment Comment Comment Comment
— - IP Pools are enabled upon entry in the table. Use the
Status Status Status Status
for more complex network settings.
device as a dhcp server device as a dhcp server
button and select the
Configure Configure
Configure Configure
(optional) - the default time value for clients to retain the assigned IP Address. DHCP
(optional) - the maximum time value for clients to retain the assigned IP Address. DHCP
Other Network Settings
tabs.
Network > DHCP Server Network > DHCP Server
Network > DHCP Server Network > DHCP Server
button to disable or delete existing table entries.
Edit Edit Edit Edit
2-9