Table of Contents
Advertisement
7. Place the remaining type "A" coal
between the front and rear base coals.
The letter "A" should be upside down
with its rear face between the right
and centre coals of the rear base coal.
Angle the coal so that the gap
between it and the type "B" coal to its
right is appreciably larger than the
gap between it and the type "A" coal
to its left but do not have it touching the type "A" coal. This will give the best flame
effect. See figure 32.
13. CERAMIC PEBBLE INSTALLATION
This section is for models supplied with 'Pebbles' effect fuel bed only.
For 'Coal fuel bed' see section 12
1. Place the rear base pebble in the firebox. It
should rest on the ledges at the rear sides of the
burner unit. See figure 33. When located gently
move the rear base pebble so that it is as far
forward as possible. The amount of movement will
be negligible (See figure 33).
2. Place the front base pebble in the firebox with its
bottom front locating over the front rim of the
firebox. Pull the pebble forward so that it locates
immediately behind the front rim of the firebox.
(See figure 34).The front base pebble will touch
the rear base pebble as it is located.
INSTALLER GUIDE
Figure 32.
Page 28
Figure 33 Rear Base Pebble
Position
Figure 34 Front Base Pebble
Position
Hide quick links:
Advertisement
Table of Contents
