Firebox Installation; Method 1- Front Fixing To Fireplace Surround; Method 2 - Cable Retention - Valor Quantum & Urban 746 Installer's Manual

INSTALLER GUIDE
Fit the restrictor as shown in figure 12 using the two
screws provided.
Figure 12. Fixing restrictor

9. FIREBOX INSTALLATION

9.1

Method 1- Front Fixing to Fireplace Surround

1. Make sure that the fireplace front surround area is
sound enough to take the rawlplugs and woodscrews. If
necessary, make sound with a suitable cement.
2. Place the hotbox centrally in the fireplace in the
position in which it is to be permanently installed. If a
concealed connection is being used, insert the hotbox
into the fireplace feeding the supply pipe through the
pierced hole in the rear seal.
3. Mark the fireplace front surround through the four
fixing holes in the side flanges of the hotbox. See figure
13.
4. Remove the hotbox. Drill four holes in the fireplace
front surround at the marked positions using a no.12
masonry drill.
5. Insert a rawlplug into each hole.
Figure 13. Front Fixing
6. Place the hotbox back in position in the fireplace.
7. Fit a woodscrew through each hole in the hotbox
flanges and tighten to seal the box to the fireplace surround.

9.2 Method 2 - Cable Retention

1. Make sure that the relevant areas at the fireplace back are sound enough to take the
eyebolts and screws. If these areas have deteriorated due to prolonged use they should
be made sound with a suitable cement.
2. Drill four holes in the rear wall of the fireplace for the eyebolt plugs. The holes
Page 20