Table of Contents
Advertisement
INSTALLER GUIDE
7. GAS SUPPLY CONNECTION
A nut and olive are provided for an 8mm pipe inlet connection to the 'T' connector at
the bottom front of the appliance. The 'T' connector can be rotated to allow a
connection from any direction. The 'T' connector includes a valve for isolating the gas
supply and a pressure test point.
The supply pipe must be rigid material. Flexible pipe must not be used.
Concealed Supply Pipe Connection
If a concealed connection from inside the fireplace is required then, before the
appliance is fitted into the fireplace it will be necessary to extend the supply line so
that it will project through the hole in the back of the hotbox and run to the 'T'
connector at the front. The pipe run from the supply line up to the rear opening in the
hotbox must be kept away from the area which will be taken by the hotbox when it is
installed. Note that the centre of the appliance inlet 'T' connector is 25mm above the
fireplace floor. The inlet 'T' connector should be fitted to the supply pipe at this stage.
8. PREPARING APPLIANCE FOR INSTALLATION
8.1 Appliance Preparation
1. Remove any transit tape and packing and
inspect for any evidence of mishandling
which might affect the performance. Each
unit is flame tested before it leaves the
factory and as a result there may be slight
discoloration around the burner ports.
Quantum model
2. Remove the two surround securing
screws (See figure 8). Remove the outer
surround by gently pulling the base of the
outer surround forward whilst lifting clear
of the case support bracket.
Figure 8. Case securing screws
All models
3. Detach the burner unit from the hotbox by removing two screws - See figure 9. Lift
the burner unit clear.
Page 18
Hide quick links:
Advertisement
Table of Contents
