Table of Contents
Advertisement
4. Detach the burner unit
from the hotbox by removing
two screws – See figure 50.
5. Replace in the reverse
order.
17.4 To Remove the Pilot
Unit
1. Remove the burner unit -
See section 17.3.
2. If lying the burner on its
back, ensure that the
worksurface is suitably
protected This will avoid
damage to the worksurface.
3. Detach the pilot pipe from the pilot
unit.
4. Detach the thermocouple from the
gas valve
5. Detach the electrode lead from the
underside of the electrode tab.
6. Remove the two screws securing
the pilot unit . See figure 51.
7. Refit in the reverse order.
Note:
1.
atmosphere sensing device. It
must be replaced as a whole
assembly. Its individual
components are not
separately replaceable.
INSTALLER GUIDE
Urban
Figure 49. Front surround removal
The pilot unit is an
Figure 50. Burner attachment points
Figure 51. Pilot unit removal
Page 37
Quantum
Hide quick links:
Advertisement
Table of Contents
