Ceramic Coals & Walls Installation - Valor Ultimate Turbochim BR517R Installer's Manual

P A R T 1 0 : C E R A M I C C O A L S & W A L L S I N S T A L L A T I O N
10.1 With its feather
edge at the top, place
the ceramic rear wall
into the channel at the
back of the fire box.
Push the wall flat
against the rear of the
fire box. (See figure
18)
.
10.2 Place the
two halves of the
front base coal in
the burner
compartment so
that they rest on
the ledges at the
sides and front.
Pull the coals
forward so that
they are
immediately
behind the front
rim of the burner
compartment (See
fig. 19).
10.3 Place the
rear base coal in the
burner compartment
behind the front coal.
Its rear face should
touch the rear ceramic
wall (See figure 20).
Fig. 18 Ceramic rear wall
installation
Fig. 19 Front coal installation
Fig. 20 Rear base coal
installation
10.4 The ceramic
side walls are marked
at the rear
bottom corners "L"
(Left side) & "R"
(Right side). Place the
side walls against the
sides of the fire box
and in the recesses at
the sides of the base
coals. The markings
"L" & "R" should be
at the back bottom
corners and facing to
the centre of the
back of the firebox
(See figure 21)
.
10.5 Install the 5
loose coals as
follows. The
smooth surfaces of
the coals should be
at the bottom and
back.
10.5.1Select the
two largest coals.
Place them in the
central two valleys
of the front coal
(See figure 22).
10.5.2Place the
three remaining coals
behind and
approximately
midway between each
of the coals in the
front row (See figure
23).
21
Fig. 21 Ceramic side walls
installation
Fig. 22 Front row inner coals
Fig 23 Middle row of coals