Ceramic Coals Installation - Valor Quantum & Urban 746 Installer's Manual

INSTALLER GUIDE

12. CERAMIC COALS INSTALLATION

This section is for models supplied with 'Coal' effect fuel bed only.
For 'Pebble fuel bed' see section 13
1. Place the rear base coal in the firebox.
It should rest on the ledges at the rear
sides of the burner unit. When located
gently move the rear base coal so that it
is as far forward as possible. The amount
of movement will be negligible (See
figure 26).
2. Place the front base coal in the firebox
with its bottom front locating over the
front rim of the firebox. Pull the coal
Figure 26. Rear Base Coal Position
forward so that it locates immediately
behind the front rim of the firebox.
(See figure 27).The front base coal
will touch the rear base coal as it is
located.
Figure 27. Front base coal position
Page 26