Community (Com) Group Speaker Call - Siemens ROLMphone 120 Series User Manual

Note: A com group call overrides Forwarding and (on Version 6.2
and higher) Do Not Disturb mode. (See "Forwarding" on page
5-1 and "Do Not Disturb" on page 6-1.)

Community (Com) Group Speaker Call

Community (Com) Group Speaker Call lets you make a two-way call
to the speaker of another phone in your community (com) group by
dialing a short code instead of an extension. If the party you are calling
does not have a speakerphone, they must pick up the handset to
answer.
If the party being called picks up the handset, the call is converted to a
regular call. If the party being called is busy, you will receive a busy
tone.
This feature is much like the Two-Way Speaker Call feature, except
that the party you are calling must be a member of your community
(com) group. (See "Two-Way Speaker Call" on page 3-32.)
For more information about com groups, see "Community (Com)
Group Call" on page 3-18.
To make a com
group speaker
call
If you are a member of a com group and want to make intercom calls
to the same member often, you can set up an auto intercom repdial key.
To do this, set up a repdial key with the Intercom feature access code
(* * 6) followed by the com code of another member in your group.
(See "Repertory Dialing (Repdial)" on page 3-24.)
Press the Intercom (INTRCOM) key, or get
a dial tone and dial * * 6.
Dial the member's com code.
You will hear the confirmation tone. The
other party's phone will beep twice.
Begin speaking. If the other party does not
have a speakerphone, they must pick up the
handset to answer. You and the other party
will hear repeated intrusion tones until they
pick up the handset.
Making Calls 3-19