Siemens ROLMphone 120 Series User Manual page 83

If you press a repdial key while you are on a call, Versions 6.0
and 6.1 will place the first party on consultation hold before
dialing. To return to the first party, press the CONNECT key.
To set up a
repdial key
Press the Program key. The Program status
light turns on. If you have a display phone,
PRESS FEATURE KEY OR DIAL CODE
is displayed.
Press the repdial (R-) key you want to set
up. If you have a display phone, REPDIAL
is displayed, followed by either the dialing
sequence or NOTHING STORED. NEW
NUMBER? is then displayed.
Enter the dialing sequence you want to
assign to the R- key. If you make an error
while entering the dialing sequence, press
the Clear key to cancel your changes. Then
enter the sequence again.
If you want to set up another R- key, press
the Store key. If you have a display phone,
STORED is displayed. Repeat the two
previous steps.
To end setup, press the Program key. The
Program status light turns off. If you have
a display phone, STORED is displayed.
On your faceplate, use a pencil to label
each R- key you changed with the name of
the feature or person it dials.
Making Calls 3-25