Community (Com) Group Call - Siemens ROLMphone 120 Series User Manual

Note: If you are talking on the phone, you can press the Buzz key
without interrupting your call.
Buzz overrides Do Not Disturb mode. (See "Do Not Disturb"
on page 6-1.)

Community (Com) Group Call

Community (com) groups can be set up at the communications server
so that the members of a group can call each other by dialing a short
com code instead of an extension. A call from a com group is signalled
by a long ring.
On Version 6.1, you can only be a member of one group at a time.
On Version 6.2 and higher, you can be a member of more than one
group at a time and can be listed in a group more than once. You can
also be assigned access to groups of which you are not a member.
To call a member of a com group to which you have access, you dial
the com group access code followed by the com code for that member.
Your system administrator can tell you the com group access codes.
Com groups are set up at the communications server. Groups of up to
ten members have one-digit codes. Groups of more than ten members
have two-digit codes. Ask your system administrator for a list of the
com group members to whom you have access.
If the party being called is busy, you will receive a busy tone.
To call someone
in a com group to
which you have
access
3-18 ROLMphone 120/240/400 Series User Guide
Hang up.
Get a dial tone.
Dial the com group access code.
Dial the party's com code.