AMX Modero MVP-5200i Operation/Reference Manual page 61

Project Information Page (Cont.)
Sales Order:
Purchase Order:
AMX IR 38K Assigned
Port:
AMX IR 455K Assigned
Port:
IR User Def1 Port:
IR User Def2 Port:
Build Number:
Creation Date:
Revision Date:
Last Save Date:
Blink Rate:
Job Comments:
Cradle Sensor Port:
Cradle Sensor Channel: Displays the channel used to broadcast the charging cradle sensor status.
IR receivers and transmitters on G4 panels share the device address number of the
panel.
MVP-5200i Modero Viewpoint Widescreen Touch Panel
Displays the sales order information.
Displays the purchase order information.
Displays the AMX 38 kHz IR channel port used by the IR Emitter on the panel.
• This information is specified in TPD4 (Project Properties > IR Emitters &
Receivers tab).
• For example, if you set the AMX IR 38K Port to 7 and then put a button on the
panel with a channel code of 5 and a port of 7, it will trigger the IR code in slot 5
of the AMX IR 38K Port.
Displays the AMX 455 kHz IR channel port used by the IR Emitter on the panel.
Displays the primary channel port used by the IR receiver on the panel.
Displays the secondary channel port used by the IR receiver on the panel
Displays the build number information of the TPD4 software used to create the
project file.
Displays the project creation date.
Displays the last revision date for the project.
Displays the last date the project was saved.
Displays the feedback blink rate, in 10-second increments.
Displays any comments associated to the job (from the TPD4 project file).
Displays the port used by the charging cradle sensor.
Setup Pages
53