AMX Modero MVP-5200i Operation/Reference Manual page 181

4. Insert the five screws and replace the rubber feet atop the two upper screws, using the replacement
rubber feet and bottom label included in the Battery Pack Kit (FIG. 5).
Bottom screw
holes
Speaker
Front of MVP-5200i
FIG. 92
MVP-5200i back plate installation
The three bottom screws are shorter than the top two screws. The screws must be
re-assembled in their original location or the device can be damaged during
reassembly.
5. Restart the device to confirm that the new battery is functioning correctly.
6. Attach the residual voltage discharge adaptor (SAA5966-27-A) to the old battery and allow any
remaining charge to dissipate. Note that the adaptor may become warm to the touch for up to 12
hours.
MVP-5200i Modero Viewpoint Widescreen Touch Panel
Rubber feet
Upper screws
Back plate
Battery Life and Replacement
Bottom label
Bottom
screws
173